Thank You for purchasing from Sharp Edge Designs!
Applied properly, your decal will look great for many years to come.
*Apply your new vinyl decal to clean, smooth and hard surfaces only. Wiping with rubbing alcohol on a cloth is suggested to remove any oil, wax, dirt or de-icing chemical.
*Application to freezing cold or extremely hot surfaces is not recommended.
*Do not get decal wet or leave in extreme hot or cold places while still on paper backer. Once this paper backer is removed for decal application then it can weather the elements.
1. Place decal face down and slowly remove the paper backer, leaving the vinyl decal attached to the front "transfer" sheet. Make sure all pieces are remaining.
2. Place the decal slightly hovering over where you want it to be applied. Then apply pressure starting at one side and working towards the other with a flat object. A credit card works well as a "squeegee" for this purpose. Use caution and double check that it is straight and where you want it as once the decal makes contact with the surface, it is stuck and you can’t reposition it.
3. Carefully and slowly peel off the front “transfer” sheet at a downward angle. Watch closely that all the decals details are sticking to your surface and not the transfer sheet. This could make a rip in your decal if you are not careful. If an edge of the decal lifts from the surface, simply use the squeegee to smooth it back down again and then retry.
*If you do get air bubbles in your decal just put a tiny pin hole in the center to puncture.
*DO NOT place in the path of a wiper as it will eventually wear the decal.
PLEASE FOLLOW ALL INSTRUCTIONS AS I DO NOT REFUND MONEY FOR DAMAGED DECALS DUE TO IMPROPER APPLICATION TECHNIQUE.
*Application to freezing cold or extremely hot surfaces is not recommended.
*Do not get decal wet or leave in extreme hot or cold places while still on paper backer. Once this paper backer is removed for decal application then it can weather the elements.
1. Place decal face down and slowly remove the paper backer, leaving the vinyl decal attached to the front "transfer" sheet. Make sure all pieces are remaining.
2. Place the decal slightly hovering over where you want it to be applied. Then apply pressure starting at one side and working towards the other with a flat object. A credit card works well as a "squeegee" for this purpose. Use caution and double check that it is straight and where you want it as once the decal makes contact with the surface, it is stuck and you can’t reposition it.
3. Carefully and slowly peel off the front “transfer” sheet at a downward angle. Watch closely that all the decals details are sticking to your surface and not the transfer sheet. This could make a rip in your decal if you are not careful. If an edge of the decal lifts from the surface, simply use the squeegee to smooth it back down again and then retry.
*If you do get air bubbles in your decal just put a tiny pin hole in the center to puncture.
*DO NOT place in the path of a wiper as it will eventually wear the decal.
PLEASE FOLLOW ALL INSTRUCTIONS AS I DO NOT REFUND MONEY FOR DAMAGED DECALS DUE TO IMPROPER APPLICATION TECHNIQUE.
